Sanding Belts for use in the 35-750 Adjustable Jewelers Saw and other scroll saws.
5-3/8" long x 1/4" wide, 4 ea. 180 grit
Recommendations to make the best selection for your scroll saw:
Fits most 5″ scroll saws (Craftsman®, Delta®, DeWalt®, Excalibur®, Ryobi®), but modifications may be required to throat insert or table opening depending upon width of sander used. Be sure to check your table/ throat plate opening before purchasing sanders.
DeWalt® & Excalibur® Scroll Saws only accept the 1/4″ sanders unless you drill the table hole larger.
Delta®: use side mount, cut table insert to fit sander, or remove table insert.
Ryobi® SC 162, 162VS & 165
Does not fit RBI®, Reliant®, or Moto-Shop®.
These sanding belts fit most conversion kits for mounting blades with plain ends on pin end saws.