Cobra 100 amp ESC 2-6S w/BEC

Article number: 011948
Cobra 100 Amp ESC Specifications
 Weight (Without Connectors)  69.8 grams (2.46 oz)
 Max Continuous Current  100 Amps
 Burst Current rating (15s)  125 Amps
 Operating Voltage Range  6 to 26 Volts
 Number of Li-Po cells  2 to 6 cells
 Number of Ni-XX cells  6 to 20 cells
 Number of Li-Fe cells  2 to 7 cells
 Switching BEC Output  6 amps @ 5.5 Volts
 ESC Size (Inc. Caps, in mm)  72 x 33 x 14
 ESC Size (Inc. Caps, in inches)  2.83 x 1.30 x 0.55

Easy Set-up and Operation
● Basic Programming available through Throttle Stick
● Throttle Range automatically detected and set for smooth, linear throttle response
● Three different types of Low Voltage Cut-off available for Li-Po, Ni-XX or LiFe batteries
● Three different LVC levels for each cell type: 3.2, 3.0 or 2.8 Volts/cell for Li-Po batteries, 0.9, 0.8 or 0.6 Volts/cell for Ni-XX batteries and 2.8, 2.5 or 2.2 Volts/cell for Li-Fe batteries
● LVC type can be set to Hard Cut-off or Power Reduction Mode
● Three different brake levels, Hard, Medium or Off
● Three different timing modes, High, Low and Auto
● Three different Motor Acceleration Rates, High, Medium and Low
● Safe Start-Up: The ESC will not arm until the throttle is in the idle position
● Locked-Rotor Protection: If the motor is blocked so the prop cannot rotate, the ESC will automatically shut down to prevent damage
● PWM Frequency is set to 8KHz for best operation on a wide range of motors
● Over Temp Protection: Shuts down the ESC output if temperature exceeds 230F (110C)
● Auto Power Cut-off: If the throttle signal is lost for more than 3 seconds, the throttle will reduce to idle to prevent fly-aways.

0 stars based on 0 reviews